S-Inspiration Inspiration Fitness Bedienungsanleitung PDF herunterladen (Seite 23)

Floating Pulley Assembly

Step 18

1 - Lower Cable

1 - 5/16” x 1 ¼” Shoulder bolt

1 - 5/16” Lock Nut

1 - Plastic Ball

1 - “U” Bracket

1 - Spring Clip

1 - 3/8” x 2” Hex Bolt

1 - 3/8” x 2 ¼” Bolt (Blue Dot)

1 - 3/8” x 1 ½”Hex Bolt

4 - 3/8” Flat Washers

2 - 3/8” Lock Nut

1 – 1/2” Step Spacer

Lower Cable “U” End , Cable Anchor Plate

Lower Cable inside the tube

3/8” X 2” Bolt

Lower Cable inside the tube 3/8” x 1 ½” Bolt

3/8” X 2 ¼” Bolt (Blue Dot)

1/2” Ste

ace

Step 18: Select a Lower Cable (with “U” End). Lay it out assuring it is not kinked. Attach the “U” clip to

the Cable Anchor Plate upper center hole. Route the cable up through the Floating Pulley Assembly

then down around the rear pulley position and into the Base Beam. Push the cable forward through

the Base Beam past the front pulley position. Route the cable out through the smaller hole and up

around

the Lower Cable Column Mount Pulley, capturing the cable with only the lower guide tab.

Install the front and rear Pulleys

assuring that the cable is seated in their grooves. Route the cable

up the Cable Column and between the Dual Pulleys on the Cable Column Slider. To secure the

Cable End, place one Plastic Ball onto the end of the cable. Next slide the cable end into the slot of

the Cable End “U” Bracket. Finally, attach the Spring Clip to the “U” Bracket using a 1 ¼”L shoulder

bolt and 5/16” lock nut. Slide the retainer “O” Ring tight against the Plastic Ball to complete using:

One (3/8” x 1 ½” Hex Bolt) One (Plastic Ball)

One (3/8” x 2” Hex Bolt) One (“U” Bracket)

One (3/8” x 2 ¼” Bolt (Blue Dot) One (Spring Clip)

One (Step Spacer) One (5/16” x 1 ¼” Shoulder Bolt)

Four (3/8” Flat Washers) One (5/16” Lock Nut)

Two (3/8” Lock Nuts)

(Wrench Tighten Now)

Page 20

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Keine Kommentare

S-Inspiration Inspiration Fitness Bedienungsanleitung Seite 23